-70%
171351396065374_0.jpg
171351396130842_1.jpg

LAMP DRIVER BOARD (BALLAST) EUC 300E B/F11 BENQ W7000 W7500 Verkauf

Power Board for BenQ Projector W2700 M1837900HQ PT VIP H8 OSRAM Mode
Power Board BenQ Projector W1350 W3000 W1090 TH683 MW855UST Mode
0 out of 5

16,80€

SKU: US-8646586827089 Category:
View cart
Add to wishlist

Description

LAMP DRIVER BOARD (BALLAST) EUC 300E B/F11 BENQ W7000 W7500

Original Ballast (Lamp Driver Board, Ignition Coil)  EUC 300E B/F11 5D.J3907.001 for BenQ Projector W7000, W7500

Part condition : NEW
iNeedParts stock code : 5D.J3907.001
Ballast code : EUC 300E B/F11
Compatibility : BenQ W7000, BenQ W7500

Genuine spare part suitable for select models of BenQ Video Projectors. Please check the suitable model fit list to ensure that this is the correct part for your BenQ product.

For all BenQ Products we offer Fanatical Services & Unrivaled Expertise since 1994

If you have any question or if you don’t know if the part is compatible with your BenQ product, please send a message using iNeedParts Service Department Form. Do you need other BenQ Spare Parts and is not listed?. Contact us by indicating your BenQ Product & defective simptoms.

If the Lamp Driver Board for your BenQ Projector W7000 or W7500 has become defective, there’s no need to worry about buying a whole new BenQ Projector – simply replace it with this spare today. This genuine spare from iNeedParts can be fitted to ensure your old BenQ Projector is looking and working at its best once again

Express Shipment available in the European Union

iNeedParts repair W7000, W7500 projector hints :

Prior considering to buy an new ballast, you should check (correct order of operations):

1. Are you able to power on the projector? (have at least one LED ON?)
2. The Colour Wheel is spinning?
3. You have OEM or Original Lamp inside? Try with original one (with proof) first!

Are OEM Lamps really Original?

When purchasing lamps, it is important to read the fine print.  More often than not, an OEM lamp simply means that the lamp is manufactured by one of the 6 or so major manufacturers, and is not actually an original lamp.  It is important that you evaluate your needs: if projector uptime is critical, under no circumstances should you use a cheap OEM bulb from an unknown source.  Most critically, these cheap lamps are known to cause power fluctuations, leading to damaged PCB components and blown ballasts.

Ballast working principle:

Ignition failure can be detected as the electronic ballast is in open-circuit or hot lamp state, while current is small. The ballast attempts to ignite the lamp for three times, which interval is 10 minutes. If the lamp is in hot-lamp state, it can be cooled down during the interval and can be ignited normally. If the lamp is in open-circuit state, it can not be ignited during the intervals. The microprocessor stops the output of the ballast. Moreover, Short-circuit protection can be detected by the lamp voltage.